Set Radio-Profile Service-Profile - 3Com 3CRWX120695A Command Reference Manual

set radio-profile
service-profile
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command.
Examples — The following command changes the RTS threshold for
radio profile rp1 to 1500 bytes:
WX4400# set radio-profile rp1 rts-threshold 1500
success: change accepted.
See Also
"set radio-profile mode" on page 287
"display radio-profile" on page 254
Maps a service profile to a radio profile. All radios that use the radio
profile also use the parameter settings, including SSID and encryption
settings, in the service profile.
Syntax —
set radio-profile name service-profile name
radio-profile name
characters, with no spaces.
service-profile name
alphanumeric characters, with no spaces.
Defaults — A radio profile does not have a service profile associated
with it by default. In this case, the radios in the radio profile use the
default settings for parameters controlled by the service profile. Table 58
lists the parameters controlled by a service profile and their default
values.
Table 58 Defaults for Service Profile Parameters
Parameter
auth-dot1x
auth-fallthru

set radio-profile service-profile

— Radio profile name of up to 16 alphanumeric
— Service profile name of up to 16
Radio Behavior When Parameter Set
Default Value to Default Value
enable When the Wi-Fi Protected Access (WPA)
information element (IE) is enabled, uses
802.1X to authenticate WPA clients.
web-auth Uses Web AAA for users who do not
match an 802.1X or MAC authentication
rule for the SSID requested by the user.
291