Set Log - 3Com 3CRWX120695A Command Reference Manual

494 C 20: S
HAPTER YSTEM
WX4400# display log trace facility ?
<facility name>
ASO, BOOT, CLI, CLUSTER, COPP, CRYPTO, DOT1X, ENCAP, ETHERNET, GATEWAY, HTTPD,
IGMP, IP, MISC, NOSE, NP, RAND, RESOLV, RIB, ROAM, ROGUE, SM, SNMPD, SPAN, STORE,
SYS, TAGMGR, TBRIDGE, TCPSSL, TELNET, TFTP, TLS, TUNNEL, VLAN, X509, XML, MAP,
RAPDA, WEBVIEW, EAP, PORTCONFIG, FP.

set log

L C
OG OMMANDS
History — Introduced in MSS Version 3.0.
Examples — Type the following command to see the facilities for which
you can view event messages archived in the buffer:
Select one of: KERNEL, AAA, SYSLOGD, ACL, APM, ARP,
See Also
"clear log" on page 489
"display log config" on page 492
Enables or disables logging of WX and MAP events to the WX log buffer
or other logging destination and sets the level of the events logged. For
logging to a syslog server only, you can also set the facility logged.
Syntax —
set log {buffer | console | current | server ip-addr
| sessions | trace} [severity severity-level] enable | disable]
Syntax —
set log server ip-addr [severity severity-level
[local-facility facility-level]] [enable | disable]
— Sets log parameters for the log buffer in nonvolatile
buffer
storage.
— Sets log parameters for console sessions.
console
— Sets log parameters for the current Telnet or console
current
session. These settings are not stored in nonvolatile memory.
server ip-addr
address in dotted decimal notation.
— Sets the default log values for Telnet sessions. You can
sessions
set defaults for the following log parameters:
Severity
Logging state (enabled or disabled)
To override the session defaults for an individual session, type the set
log command from within the session and use the current option.
— Sets log parameters for a syslog server. Specify an