reset port
set dap
Resets a port by toggling its link state and Power over Ethernet (PoE)
state.
Syntax —
reset port port-list
— List of physical ports. MSS resets all the specified ports.
port-list
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — The reset command disables the port's link and PoE (if
applicable) for at least 1 second, then reenables them. This behavior is
useful for forcing an MAP access point that is connected to two WX
switches to reboot over the link to the other switch.
Examples — The following command resets port 5:
WX1200# reset port 5
See Also
"set port" on page 76
Configures a Distributed MAP for an MAP access point that is indirectly
connected to the WX switch through an intermediate Layer 2 or Layer 3
network.
Before configuring a Distributed MAP, you must use the set
system countrycode command to set the IEEE 802.11 country-specific
regulations on the WX switch. See "set system countrycode" on page 51.
For an MAP that is directly connected to the WX switch, use the set port
type ap command to configure an MAP access port.
Syntax —
set dap dap-num
{ap2750 | mp-52 | mp-101 | mp-122 | mp-241 | mp-252 | mp-262
| mp-341 | mp-352} [radiotype {11a | 11b | 11g}]
— Number for the Distributed MAP. The range of valid
dap-num
connection numbers depends on the WX switch model:
serial-id
serial-ID
reset port
73
model