Set Service-Profile Shared-Key-Auth - 3Com 3CRWX120695A Command Reference Manual

306 C 9: M
HAPTER ANAGED
set service-profile
shared-key-auth
A P C
CCESS OINT OMMANDS
Examples — The following command enables the RSN IE in service
profile sprsn:
WX4400# set service-profile sprsn rsn-ie enable
success: change accepted.
See Also
"set service-profile cipher-ccmp" on page 299
Enables shared-key authentication, in a service profile.
Use this command only if advised to do so by 3Com. This command does
not enable preshared key (PSK) authentication for Wi-Fi Protected Access
(WPA). To enable PSK encryption for WPA, use the
set service-profile auth-psk command.
Syntax —
set service-profile name shared-key-auth {enable |
disable}
— Service profile name.
name
— Enables shared-key authentication.
enable
— Disables shared-key authentication.
disable
Defaults — Shared-key authentication is disabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command enables shared-key authentication
in service profile sp4:
WX4400# set service-profile sp4 shared-key-auth enable
success: change accepted.
See Also
"display radio-profile" on page 254
"set radio-profile mode" on page 287