Display Vlan Config - 3Com 3CRWX120695A Command Reference Manual

WX4400# display tunnel
VLAN
--------------- --------------- --------------- ------- ----- ----- -----
vlan-eng

display vlan config

Default — None.
Access — Enabled
History — Introduced in MSS Version 3.0.
Examples — To display all tunnels from a WX switch to other WX
switches in the Mobility Domain, type the following command.
Local Address Remote Address
192.168.14.2 192.168.14.4
Table 23 describes the fields in the display.
Table 23 Output for display tunnel
Field
VLAN
Local Address
Remote Address
State
Port
LVID
RVID
See Also
"display vlan config" on page 99
Shows VLAN information.
Syntax —
display vlan config [vlan-id]
— VLAN name or number. If you do not specify a VLAN,
vlan-id
information for all VLANs is displayed.
State
DORMANT
Description
VLAN name.
IP address of the local end of the tunnel. This is the system
IP address of the wireless access switch where you enter
the command.
IP address of the remote end of the tunnel. This is the
system IP address of another WX switch in the mobility
domain.
Tunnel state:
Up
Dormant
Tunnel port ID.
Local VLAN ID.
Remote VLAN ID.
display vlan config
Port LVID RVID
1024 4096 130
99