Understanding Command Descriptions - 3Com 3CRWX120695A Command Reference Manual

30 C 1: U
HAPTER SING THE
Understanding
Command
Descriptions
C -L I
OMMAND INE NTERFACE
To see all the variations, type one of the commands followed by a
question mark (?). For example:
WX1200# display ip ?
alias
dns
https
route
telnet
To determine the port on which Telnet is running, type the following
command:
WX1200# display ip telnet
Server Status
----------------------------------
Enabled
Each command description in the 3Com Mobility System Software
Command Reference contains the following elements:
A command name, which shows the keywords but not the variables.
For example, the following command name appears at the top of a
command description and in the index:
set {ap | dap} name
The set {ap | dap} name command has the following complete syntax:
set {ap port-list | dap dap-num} name name
A brief description of the command's functions.
The full command syntax.
Any command defaults.
The command access, which is either enabled or all. All indicates that
anyone can access this command. Enabled indicates that you must
enter the enable password before entering the command.
The command history, which identifies the MSS version in which the
command was introduced and the version numbers of any subsequent
updates.
Special tips for command usage. These are omitted if the command
requires no special usage.
display ip aliases
display DNS status
display ip https
display ip route table
display ip telnet
Port
23