Set Log Trace Mbytes - 3Com 3CRWX120695A Command Reference Manual

496 C 20: S
HAPTER YSTEM
set log trace
mbytes
L C
OG OMMANDS
Defaults — The following are defaults for the set log commands.
Events at the error level and higher are logged to the WX console.
Events at the error level and higher are logged to the WX system
buffer.
Trace logging is enabled, and debug-level output is stored in the WX
trace buffer.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — Using the command with only enable or disable turns logging
on or off for the target at all levels. For example, entering set log buffer
enable with no other keywords turns on logging to the system buffer of
all facilities at all levels. Entering set log buffer disable with no other
keywords turns off all logging to the buffer.
Examples — To log only emergency, alert, and critical system events to
the console, type the following command:
WX4400# set log console severity critical enable
success: change accepted.
See Also
"clear log" on page 489
"display log config" on page 492
Changes the size of trace log files.
Syntax —
set log trace mbytes count
— Size of the trace buffer, in megabytes (MB). You can specify
count
from 1 through 50.
Defaults — The default trace buffer size is 1 MB.
Access — Enabled.
History — Introduced in MSS Version 3.0.