Display Dap Connection - 3Com 3CRWX120695A Command Reference Manual

250 C 9: M
HAPTER ANAGED
display dap
connection
A P C
CCESS OINT OMMANDS
Displays the system IP address of the WX switch that has the active data
connection for a Distributed MAP.
Syntax —

display dap connection

[dap-num | serial-id serial-ID]
— Number of a Distributed MAP for which to display
dap-num
information about its active connection.
serial-id serial-ID
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — The serial-id parameter displays the active connection for the
specified Distributed MAP even if that MAP is not configured on this WX
switch. If you instead use the command with the dap-num parameter or
without a parameter, connection information is displayed only for
Distributed MAPs that are configured on this WX switch.
If a Distributed MAP is configured on this WX switch (or another WX
switch in the same Mobility Domain) but does not have an active
connection, the command does not display information for the MAP. To
show configured Distributed MAPs regardless of connection status, use
the display dap global command.
Examples — The following command displays information for all
Distributed MAPs configured on this WX switch that have active
connections:
WX1200# display dap connection
Total number of entries: 2
DAP Serial Id
--- -----------
2 M9DE48B012F00 10.10.2.27
4 M9DE48B123400 10.10.3.34
— MAP access point serial ID.
DAP IP Address WX IP Address
--------------- ---------------
10.3.8.111
10.3.8.111