356
C
11: IGMP S
HAPTER
set igmp lmqi
set igmp mrouter
C
NOOPING
OMMANDS
Changes the IGMP last member query interval timer on one VLAN or all
VLANs on a wireless LAN switch.
Syntax —
set igmp lmqi tenth-seconds [vlan vlan-id]
lmqi tenth-seconds
the WX waits for a response to a group-specific query after receiving a
leave message for that group, before removing the receiver that sent
the leave message from the list of receivers for the group. If there are
no more receivers for the group, the WX switch also sends a leave
message for the group to multicast routers. You can specify a value
from 1 through 65,535.
vlan vlan-id
VLAN, the timer change applies to all VLANs.
Defaults — The default last member query interval is 10 tenths of a
second (1 second).
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command changes the last member query
interval on VLAN orange to 5 tenths of a second:
WX1200# set igmp lmqi 5 vlan orange
success: change accepted.
See Also
"set igmp oqi" on page 359
"set igmp qi" on page 360
"set igmp mrouter" on page 356
Adds or removes a port in a WX's list of ports on which it forwards traffic
to multicast routers. Static multicast ports are immediately added to or
removed from the list of router ports and do not age out.
Syntax —
set igmp mrouter port port-list {enable | disable}
port port-list
in the list of static multicast router ports.
— Amount of time (in tenths of a second) that
— VLAN name or number. If you do not specify a
— Port list. MSS adds or removes the specified ports