Set Spantree Portcost - 3Com 3CRWX120695A Command Reference Manual

336 C 10: STP C
HAPTER
set spantree
portcost
OMMANDS
Examples — The following command changes the maximum acceptable
age for root bridge hello packets on all VLANs to 15 seconds:
WX4400# set spantree maxage 15 all
success: change accepted.
See Also
"display spantree" on page 320
Changes the cost that transmission through a network port or ports in
the default VLAN on a wireless LAN switch adds to the total cost of a
path to the STP root bridge.
Syntax —
set spantree portcost port-list cost cost
— List of ports. MSS applies the cost change to all the
port-list
specified ports.
— Numeric value. You can specify a value from 1 through
cost cost
65,535. STP selects lower-cost paths over higher-cost paths.
Defaults — The default port cost depends on the port speed:
10Mbps — the default is 100.
100Mbps — the default is 19.
1000Mbps — the default is 4.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command applies only to the default VLAN (VLAN 1). To
change the cost of a port in another VLAN, use the set spantree
portvlancost command.
Examples — The following command changes the cost on ports 3 and 4
to 20:
WX1200# set spantree portcost 3,4 cost 20
success: change accepted.