Set Spantree Portvlanpri - 3Com 3CRWX120695A Command Reference Manual

set spantree
portvlanpri
— VLAN name or number. MSS changes the cost on
vlan vlan-id
only the specified VLAN.
Defaults — The default port cost depends on the port speed:
10Mbps — the default is 100.
100Mbps — the default is 19.
1000Mbps — the default is 4.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command changes the cost on ports 3 and 4
to 20 in VLAN mauve:
WX1200# set spantree portvlancost 3,4 cost 20 vlan mauve
success: change accepted.
See Also
"clear spantree portcost" on page 316
"clear spantree portvlancost" on page 317
"display spantree" on page 320
"display spantree portvlancost" on page 325
"set spantree portcost" on page 336
Changes the priority of a network port or ports for selection as part of the
path to the STP root bridge, on one VLAN or all VLANs.
Syntax —

set spantree portvlanpri

port-list priority value {all | vlan vlan-id}
— List of ports. MSS changes the priority on the specified
port-list
ports.
priority value
(highest priority) through 255 (lowest priority).
— Changes the priority on all VLANs.
all
— VLAN name or number. MSS changes the priority on
vlan vlan-id
only the specified VLAN.
— Priority value. You can specify a value from 0
set spantree portvlanpri 339