Dot1X Timeout Tx-Period; Dot1X Max-Req - 3Com 3CRUS2475 Command Reference Manual

dot1x timeout
tx-period

dot1x max-req

The dot1x timeout tx-period Interface Configuration mode command
sets the number of seconds that the device waits for a response to an
Extensible Authentication Protocol (EAP)-request/identity frame from the
client before resending the request. To restore the default configuration,
use the no form of this command.
Syntax
dot1x timeout tx-period seconds
no dot1x timeout tx-period
Parameters
seconds — Specifies the time in seconds that the device waits for a
■
response to an EAP-request/identity frame from the client before
resending the request. (Range: 1-65535 seconds)
Default Configuration
Timeout period is 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The default value of this command should be changed only to adjust for
unusual circumstances, such as unreliable links or specific behavioral
problems with certain clients. and authentication servers
Example
The following command sets the number of seconds that the device waits
for a response to an EAP-request/identity frame, to 3600 seconds.
Console(config)# interface ethernet g16
Console(config-if)# dot1x timeout tx-period 3600
The dot1x max-req Interface Configuration mode command sets the
maximum number of times that the device sends an Extensible
Authentication Protocol (EAP)-request/identity frame (assuming that no
response is received) to the client, before restarting the authentication

dot1x timeout tx-period

475