Performing An Snmp Set Command - 3Com SuperStack II Manual

140 C 4: W
HAPTER ORKING
Performing an SNMP
SET Command
W C L
ITH THE OMMAND INE
The following prompt is displayed:
Enter object-identifier:
2 Enter the identifier of an SNMP object.
The following prompt is displayed:
Enter count:
3 Enter the number of SNMP objects after the object specified for which
you want to retrieve information.
The SNMP object information is displayed.
An SNMP SET command allows you to modify values of SNMP objects in a
network device. You can perform an SNMP SET command on the stack
using the command on the SNMP menu.
set
CAUTION: You should not modify the values of SNMP objects unless you
have considerable knowledge and experience with SNMP.
To perform an SNMP SET command on the stack:
1 At the Top-level menu, enter:
snmp set
The following prompt is displayed:
Enter object-identifier:
2 Enter the identifier of the SNMP object.
The following prompt is displayed:
Enter type (phys,ip,gauge,cnt,num,str)[str]:
3 Enter the data type of the SNMP object.
The following prompt is displayed:
Enter value:
4 Enter the new value of the SNMP object.
I
NTERFACE