Fagor DDS Series Hardware Manual page 99

T. H3/5 Modular drives. Technical data.
Power voltage input
Power to control circuits
Consumption of the control
circuits (24 V DC)
Speed feedback
Controlling method
Communication
Interface
Status display
Protections
Frequency
·1·
Speed range with analog input
Current bandwidth
Speed bandwidth
Ambient temperature
·2·
Storage temperature
Sealing
Maximum humidity
Maximum installation altitude
Operating vibration
Shipping vibration
Approx. mass in
Higher than 550 Hz only for commercial models SPD ... - MDU (dual-use).
·1·
For high temperatures, refer to derating graphs ·power reduction graph·.
·2·
1.08 1.15 1.25 1.35
24 V DC (between 21 V DC and 28 V DC)
0.90 A
PWM, AC sinewave, vector control
Serial line to connect to a PC
Standard analog, digital SERCOS-II ring (in all models)
CAN bus (in all models).
Serial line RS-232/422 (only in MMC drives)
Over-voltage, over-current, over-speed, heat-sink temperature,
CPU temperature, motor temperature, hardware error, overload.
100 Hz (depends on the motor/drive set)
0°C/45°C (32°F/113°F)
Maximum working temperature limit: 60°C/140°F
-25°C/60°C (-13°F/140°F)
< 90 % (non condensing at 45°C/113°F)
2 000 m (6 561 ft) above sea level
kg 5.5 5.5 6.0
lb 12.1 12.1 13.2
AXD|SPD|MMC
2.50 2.75 2.85
542/800 V DC
1.25 A
Encoder
7-segment display
0-550 Hz
1:8192
800 Hz
IP 2x
1 g
1.5 g
6.5 9.0 9.0 10.0
14.3 19.8 19.8 22.0
  Drives
3.100 3.200
3.150 3.250
2.00 A
3.
14.0 19.5
30.8 43.0
HARDWARE
Ref.1912
DDS
· 99 ·