Fagor DDS Series Hardware Manual page 143

T. H3/19 Compact drives ACD/SCD... - L at 200/240 V AC. Technical data.
Line voltage
Line frequency
Internal power bus voltage
Filter capacity (µF), 900 V AC
Energy stored in the capacitors
Ballast ON/OFF
Min. Ballast resistance ()
Speed feedback
Controlling method
Communication
Interface
Status display
Speed range of analog input
Current bandwidth
Speed bandwidth
Protections
Frequency
·1·
Power for internal circuits (24 V DC)
Line voltage input
Line frequency input
Line consumption
Output voltage, max. current
Ambient conditions
Ambient temperature
·2·
Storage temperature
Sealing
Maximum humidity
Maximum installation altitude
Operating vibration
Shipping vibration
Approx. mass in
Higher than 550 Hz only for commercial models SCD...-L-MDU (dual-use).
·1·
For high temperatures, refer to derating graphs · power reduction graph ·.
·2·
ACD... - L
1.08 1.15 1.25 2.35 2.50
3-ph. from 200 (1-10 %) V AC to 240 V AC (1+10 %) V AC
280/340 V DC
330 560
43 15
Encoder
PWM, AC sinewave, vector control
Serial line to connect to a PC
Standard analog or digital via SERCOS-II (in all models)
or CAN bus (in all models)
100 Hz (depends on the motor|drive combination)
Over-voltage, over-current, over-speed, heat-sink temperature, CPU
temperature, motor temperature, Ballast temperature, hardware
error, overload. See chapter 14 of the "man_dds_soft.pdf" manual.
2-ph. from 200 (1-10 %) V AC to 240 (1+10 %) V AC
220 mA (200 V AC), 180 mA (240 V AC)
24 V DC (5 %), 100 mA. Connector X2, pins 1|2.
0°C/45°C (32°F/113°F)
Maximum working temperature limit: 60°C/140°F
-25°C/60°C (-13°F/140°F )
< 90 % (non condensing at 45°C/113°F)
2 000 m (6 561 ft) above sea level
kg 6.0 6.0 5.8 6.1
lb 13.2 13.2 12.7 13.4
SCD... - L
1.15 1.25 2.35
48 ... 62 Hz
280/340 V DC
680 330 560
0.5 C·V²
450/440 V DC
10 43 15
Encoder
7-segment display
1:8192
800 Hz
0-550 Hz
48 ... 62 Hz
IP 2x
1 g
1.5 g
6.1 6.0 5.8 6.1
13.4 13.2 12.7 13.4
  Drives
2.50 2.75
680 1150
3.
10
6.1 6.1
13.4 13.4
HARDWARE
DDS
Ref.1912
· 143 ·