Fagor DDS Series Hardware Manual page 249

7.6 Signal cables for control and communications
i
Encoder simulator from the drive to the CNC
Depending on motor feedback, the drive can generate a set of signals that
simulate those of a differential TTL encoder attached to the rotor of the
motor. The attached tables show this cable supplied by FAGOR to connect
the drive (X3) and the CNC 8055 (X1, X2, X3 or X4) / 8055i (X10, X11, X12
or X13) / 8065/8070 (LOCAL COUNTER 1/2). The attached tables show
this cable supplied by FAGOR to connect the drive and the CNC
supplied with connectors at both ends and their sales model is:
SEC-HD- cable
T. H7/16 Range of SEC-HD-  cables. The number indicates their length
in meters including the connectors.
SEC-HD-1 SEC-HD-10
SEC-HD-3 SEC-HD-15
SEC-HD-5 SEC-HD-20
Ready Made Cable SEC-HD-1/3/5/10/15/20/25/30/35
(HD, Length in meters; including connectors
Sub-D,
Cable 2x4x0.14+1x2x0.5
M15)
Signal Pin
Front View
A 1
A 2
B 3
4
B
1
11
Io 5
6
Io
5
15
AL 7
8
AL
GND 11
CHASSIS
Twisted pair. Overall shield. Metallic shield connected to CHASSIS pin
to CNC
(at the CNC end and at the Drive end)
F. H7/6
Connection of the cable for the encoder simulation and the CNC.
INFORMATION. The maximum length for SEC-HD-  cables for best
performance is 50 meters.
SEC-HD-25
SEC-HD-30
SEC-HD-35
Green
Yellow
Blue
Pink
Grey
Brown
White
Purple
Black
   Cables
7.
They are
.
(HD,
Sub-D,
Pin
F15)
Front View
1
2
3
4
15 5
5
6
7
11 1
8
11
to DRIVE -X3-
HARDWARE
Ref.1912
DDS
· 249 ·