Fagor DDS Series Hardware Manual page 161

X2 connector
10-pin connector of the compact drive and integrates the functions of the
power supply and the modular drive.
F. H3/114
Connector X2. Control.
The following table shows the values for gap, tightening torque (wire entry
holes) and other data regarding the screw-on terminals of the aerial plug-in
connector for X2 according to drive model:
T. H3/24 Aerial plug-in connector for X2. Technical data.
Connector data
Nr of poles
Gap (mm)
Min./max. tightening torque (N·m)
Screw thread
Min./max. section (mm²)
Rated current In (A)
Connection data
x1
Length to strip (mm)
Specific of the power supply
With the Error Reset input (pin 3), it possible to remove the errors at a
c o m p a c t d r i v e . S e e " r e s e t t a b l e e r r o r s " o f c h a p t e r 1 4 o f t h e
"man_dds_soft.pdf" manual. Hence, activating this input (24 V DC)
eliminates the resettable errors.
If the cause of the error persists, the status display will show the same error
again.
But if it is a major error, it can only be eliminated by powering the unit off and
back on.
Pins 1 and 2 offer a 24 V DC output for the user.
The maximum output current is 100 mA.
Specific functions of the modular drive
Control signals. With the "Drive Enable" and "Speed Enable" inputs (pins 4
and 5) together with the velocity command, it is possible to govern the motor.
The consumption of these control signals is between 4.7 and 7 mA.
The following page describes the behavior of the drive depending on these
control signals.
The "Drive Ok" contact (pins 6 and 7) will stay closed as long as the compact
drive runs properly.
1
1
2
3
4
5
6
7
8
9
10
10
ACD|/SCD|CMC
1.08|1.15|1.25|2.35|2.50
0.5/0.6
0.2/2.5
+24 V DC
0 V DC
ERROR RESET
DRIVE ENABLE
SPEED ENABLE
DRIVE OK
PROG. OUT
OP5 · F01411 ·
SCD
2.75
10 10
5.00 5.00
0.5/0.6
M3 M3
0.2/2.5
12 12
7 7
  Drives
3.
DDS
HARDWARE
Ref.1912
· 161 ·