Fagor DDS Series Hardware Manual page 115

SPD 3.200|3.250
These drives have the following connectors:
U V W
X3
X4
X5
STATUS
DISPLAY
X1
SL2 SL1
SL1
AS1
X7
AS2
GND
DRIVE
ENABLE
SPEED
ENABLE
DR.
X2
O.K.
SL2
0V
+24Vdc
FUSE
(250V)
2.5A(F)
DANGER
HIGH VOLTAGE
DISCHARGE TIME>4Min
1
U V W
RESET button
WARNING. AC touch current greater than 3.5 mA.
Install a ground wire with a section of at least 10 mm² (Cu)
or 16 mm² (Al).
F. H3/51
SPD 3.200|3.250 modular drives. Connectors.
1. Power connector for motor connection.
2. Power DC BUS that can supply power to the modular drives through metal plates.
X1. Connector that may be used to establish communication between modules through the internal bus.
X2. Connector for the basic control signals.
X3. Connector with two possible uses:
• as output of the encoder simulator.
• as input of the direct feedback for the position loop.
X4. Connector for motor feedback connection (encoder).
X5. Connector for RS-232 serial line connection.
X6. SERCOS-II or CAN interface connector.
X7. Connector for external acknowledgment of the status of the safety relay.
SL1. Slot for the cards A1, 16DI-8DO and 8DI-16DO.
SL2. Slot for the cards 16DI-8DO and 8DI-16DO.
2
X1
BOOT button.
Software update & SERCOS|CAN
transmission speed selection.
X7
AS1
AS2
GND
DRIVE
ENABLE
SPEED
ENABLE
DR.
X2
O.K.
0 V
+24Vdc
X6 X6
  Drives
X3
3.
X4
X5
2
HARDWARE
Ref.1912
· 115 ·
DDS