Fagor DDS Series Hardware Manual page 240

   Cables
7.1 Mains connection cable. Power supply - mains connection
7.
DDS
HARDWARE
Ref.1912
· 240 ·
Refer to table T. H5/14 of chapter 5 to determine the cable needed to
connect the power supply to mains. Note that compact drives have it
integrated into them.
The table T. H7/1 shows the mains connection cable supplied by FAGOR
and their sales model:
T. H7/1 Range of mains connection cables.
MPC-4x1.5 MPC-4x4
MPC-4x2.5 MPC-4x6
The 4 wires of the mains cable must be connected to the power supply or to
the compact drive (integrated power supply) as shown in figure F. H7/1 .
F. H7/1
MPC cable connection from the power supply or compact drive to mains.
The following table shows the mechanical characteristics of the terminals
(L1, L2, L3, PE) at the power supplies and at the compact drives.
T. H7/2 Mechanical characteristics of the power connectors for the power
supplies and compact drives.
Module
PS-65A
PS-25B4
XPS-25
XPS-65
RPS-80
RPS-75
RPS-45
RPS-20
ACD/SCD/CMC 1.08/1.15
ACD/SCD/CMC 1.25
ACD/SCD/CMC 2.35/2.50
SCD 2.75
* Section of the conductor that must be installed if the power supply provides
maximum power, calculated for the B2 installation method, according to UNE-
EN 60204-1:2007.
The attached table T. H7/3 gathers the regulation applicable to typical
installation of P ower D rive S ystems.
MPC-4x10 MPC-4x25
MPC-4x16 MPC-4x35
Gap Max. Max.
tightenin hole
torque section
mm N·m mm²
18.8 7
10.1 1.5
12.1 2
18.8 7
25.0 20
25.0 20
18.8 7
10.6 1.5
7.62 0.5
7.62 0.7
10.16 1.2
10.16 1.5
MPC-4x50
MPC-4x70
Max.
cable
section*
mm²
70 50
16 10
16 10
70 50
95 70
95 70
70 35
16 10
4 2.5
6 4
6 6
16 10