Fagor DDS Series Hardware Manual page 15

S H I P P I N G C O N D I T I O N S , S T O R AG E ,
D E C O M M I S S I O N A N D D I S P O SA L
Shipping
When shipping the unit, do it protected against blows and pack it in its original cardboard box with its
original packing material. If you do not have the original packaging material, pack it as follows:
1. Get a cardboard box whose 3 inside dimensions are at least 15 cm (6 inches) larger than those of the
unit. The cardboard used to make the box must have a resistance of 170 kg (375 lb).
2. Attach a label to the unit indicating the owner of the unit, his address and name of the person to contact,
type of unit and serial number.
3. In case of failure, also indicate the symptom and a short description of the failure.
4. Protect the unit wrapping it up with a roll of polyethylene or with similar material.
5. Pad the unit inside the cardboard box filling it with polyurethane foam on all sides.
6. Seal the cardboard box with packaging tape or with industrial staples.
Storage
Store the product only under the allowed ambient conditions indicated here. See this data in chapter 1 of
this manual. Always protect the product against dust and dirtiness.
Decommission and disposal
The machine manufacturer must indicate the procedure to be used for decommissioning the machine.
Respect environmental regulations. Observe that the AXD/SPD drives do not carry batteries.
Bear in mind the storage and shipping requirements when disposing of the AXD/SPD units.
Recycling. The product is made of various materials that may be recycled and eliminated separately. Get
rid of the product in compliance with local regulations.
DDS
HARDWARE
Ref.1912
· 15 ·