Igmp Snooping Vlan - ZyXEL Communications XMG1915 Series User Manual

39.4 IGMP Snooping VLAN

Click SWITCHING > Multicast > IPv4 Multicast > IGMP Snooping VLAN to display the screen as shown. See
IGMP Snooping and VLANs on page 223
Note: You can perform IGMP snooping on up to 16 VLANs.
Figure 158 SWITCHING > Multicast > IPv4 Multicast > IGMP Snooping VLAN
The following table describes the labels in this screen.
Table 117 SWITCHING > Multicast > IPv4 Multicast > IGMP Snooping VLAN
LABEL
IGMP Snooping VLAN
Mode
Apply
Cancel
VLAN
Use this section of the screen to add VLANs on which the Switch is to perform IGMP snooping.
Index
Name
VID
Add/Edit
Delete
Chapter 39 Multicast
for more information on IGMP Snooping VLAN.
DESCRIPTION
Select auto to have the Switch learn multicast group membership information of any VLANs
automatically.
Select fixed to have the Switch only learn multicast group membership information of the
VLANs that you specify below.
In either auto or fixed mode, the Switch can learn up to 16 VLANs.
The Switch drops any IGMP control messages which do not belong to these 16 VLANs.
You must also enable IGMP snooping in the SWITCHING > Multicast > IPv4 Multicast > IGMP
Snooping screen first.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
This is the index number of the IGMP snooping VLAN entry in the table.
This field displays the descriptive name for this VLAN group.
This field displays the ID number of the VLAN group.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click Add/Edit to create a new entry or edit a selected one.
Click Delete to remove the selected entries.
XMG1915 Series User's Guide
226