Table of Contents
Advertisement
Accepting Licensed Internal Code Changes (Hardware Management
Console)
If there are no Hardware Management Console LIC Changes to accept go to "Backup Critical Data
(Hardware Management Console and Support Element)" on page 6-60.
This procedure allows you to accept licensed internal code changes as a permanent part of the
Hardware Management Console's licensed internal code.
Note: Once a change is accepted, it cannot be removed. A new change must be retrieved and accepted
to replace it.
1 Starting the operation
The Hardware Management Console Workplace
panel displays.
1. Open Console Actions from the Views
area
2. Open Change Console Internal Code
from the Console Actions Work Area
2 Accepting the changes
The Change Internal Code panel displays.
1. Select Accept all installed changes that
were activated from the menu.
Note: If Accept all installed changes
that were activated is "grayed out"
it means there are no changes to
accept. If there are no changes to
accept, go to "Backup Critical Data
(Hardware Management Console
and Support Element)" on
page 6-60.
2. Select OK.
3 Selecting the changes
The Select Internal Code Changes panel displays.
1. Select All internal code changes from the
menu.
2. Select OK.
4 Confirming the request
The Confirm the Action panel displays.
1. Select Accept.
6-58
Installing the System
Advertisement
Table of Contents
