Table of Contents
Advertisement
Restoring Pre-Configuration (Support Element)
This process requires the CPC LOCATIONS diskette created in STEP 2 of "Creating CPC Locations
Diskette" on page 6-65 and the SE-RESTORE1 diskette (Part 1956504).
This procedure is to be performed on each Support Element. Each Support Element is associated
with a CPC listed on the CPC LOCATIONS diskette label created in STEP 2 of "Creating CPC
Locations Diskette" on page 6-65
1 Restoring the Support Element
1. Place the SE-RESTORE1 Diskette in the
Support Element drive A:
2. Press ALT+CTRL+DELETE to re-boot the
Support Element
3. If the HARD DISK UPGRADE or RELOAD
panel displays, press ESC key.
OR
4. If the SUPPORT ELEMENT RESTORE
PROGRAM panel is displayed,
press and hold the CTRL key and then
depress the BREAK key.
NOTE.
It takes approximately 55 seconds for
the RESTORE PROGRAM screen to be
displayed.
5. Remove the SE-RESTORE1 diskette from
drive A:.
6. Insert the CPC LOCATIONS diskette into
drive A:.
7. ENTER
COPY XXXX.C E: (Where XXXX
equals the EIA location for the CPC
EXAMPLE=A18A.
8. ENTER
COPY XXXX.D E: (Where XXXX
equals the EIA location for the CPC
EXAMPLE=A18A.
9. Remove the CPC LOCATIONS diskette
From drive A:.
Chapter 6. Completing the Installation
6-67
Advertisement
Table of Contents
