2 Verifying Hardware Management Console
Data.
1. ENTER
E:
to make the E: drive the
current drive.
2. ENTER
DIR: IQYBMCC*.RAM
NOTE.
You should have a IQYBMCCx.RAM for
each Hardware Management Console
attached to your system.
The "x" will match the Hardware
Management Console number that was
recorded at the start of this procedure
HMC2, HMC3 or HMC4.
3. ENTER
DIR: IQYBMCD*.RAM
NOTE.
You should have a IQYBMCDx.RAM for
each Hardware Management Console
attached to your system.
The "x" will match the Hardware
Management Console number that was
recorded at the start of this procedure
HMC2, HMC3 or HMC4.
3 Loading Pre-configuration
1. ENTER
A: to make the A: drive the
current drive.
2. ENTER
LOADRAM E:\IQYBMCCx.RAM C:
/C/M/S/NE/D
3. ENTER
LOADRAM E:\IQYBMCDx.RAM D:
/C/M/S/NE/D
NOTE.
The "x" should match the Hardware
Management Console number that was
recorded at the start of this procedure
HMC2, HMC3 or HMC4. For (HMC2)
use 2, for (HMC3) use 3 etc.
6-64
Installing the System
Note: If your system has more then one
Hardware Management Console you need
to return to Preparing the Hardware
Management Console on page 6-63.
Repeat this procedure on each Hardware
Management Console before continuing.