Table of Contents
Advertisement
Enabling Service Status
1 Selecting the options
From the Hardware Management Console
Workplace panel.
1. Open Task List from the Views area
2. Open Service from the Task List Work
Area
3. Open Groups from the Views area
4. Drag and Drop Defined CPC's on Service
Status in the Service area
5. Select a CPC to customize.
6. Select Options from the action bar.
7. Select Enable service status from the
pull-down.
8. Repeat 5, 6, and 7 until all CPC's are
enabled.
9. Select Save
10. Select OK
11. Select Cancel to return.
2 Time Synchronization
Skip this step if performed during "Defining Support
Element to the Hardware Management Console" on
page 6-10.
1. Open Task List from the Views area
2. Open Object Definition from the Task List
Work Area
3. Open Groups from the Views area
4. Select Defined CPC's from the Groups
Work Area
5. Drag and drop the Defined CPC's on
Change Object Definition in the Object
Definition area.
6. Select Enable for Time Synchronization
to satisfy the noted conditions.
7. Select Save
The Change Object Definition Task
Confirmation panel displays.
8. Select Yes
9. Go to "Change Object Definition" on page
6-12
Note: Since only ETR (External Time Reference)
can provide a synchronized time source, it
is not recommended to have several
non-synced potential time sources.
For customers with no ETR select only one
Support Element to Enable for Time
Synchronization.
For customers with some ETR and some
non-ETR CPCs allow all Support Element's
attached to CPCs with ETR to be potential time
sources.
Chapter 6. Completing the Installation
6-11
Advertisement
Table of Contents
