Table of Contents
Advertisement
Installing Emulated I/O cables
LAN (Local Area Network) Connections
Ethernet/Token-Ring located in LG12, LG11, and LG10
The (Token-Ring) feature card requires special handling for configuration. Each card has two
connectors: an RJ-45 and a 9 pin D-shell. Only one will be used. Configuration of a LAN port
is done each time the card is powered on and only one wrap connector or LAN cable is
plugged on each port. Each port will be configured to match the wrap plug or LAN cable that
is plugged. If there is not a wrap connector or LAN cable plugged for a port, no configuration
takes place.
In addition to the combined (Ethernet/Token-Ring) slots, there is a Token-Ring only adapter
available in slot LG09 and an Ethernet connection available at LG17 that can become emulated
I/O.
Also available are WAC (Wide Area Connector) and MPM2 (MultiPort Model 2) adapters
Ensure the configuration matches the customer order. Consult the chart Table 6-2 for the
correct plugging sequence.
The following chart shows the slots that the cards will be installed in according to the
customer's order. This is not the order that the adapters will be configured. The last adapter
installed of an adapter type will be the first adapter seen by the operating system at power-on.
Token ring wrap plug (part 08J5792) RJ-45 connector.
Token ring wrap plug (part 6165899) D-Shell connector.
Ethernet UTP wrap plug (part 00G2380) RJ-45 connector.
Table 6-2. 7060 Server PCI and ISA Feature Support Plugging
Sequence
Installed order
For LAN Features:
Ethernet 1 (EN1)
Ethernet 2 (EN2)
Ethernet 3 (EN3)
Ethernet 4 (EN4)
Token Ring 4 (TR4)
Token Ring 3 (TR3)
Token Ring 2 (TR2)
Token Ring 1 (TR1)
For Communication Features:
WAC 1
WAC 2
WAC 3
MPM2 1
MPM2 2
6-34
Installing the System
Plug Location
Contained in SBC
(Slot LG17 and LG18)
LG12
LG11
LG10
LG12
LG11
LG10
LG09
LG19
LG20
LG21
LG21
LG20
Advertisement
Table of Contents
