IBM Multiprise 3000 S/390 Installation Manual page 146

2 Loading Pre-Configuration
1. Insert the SE-RESTORE1 diskette into
drive A:.
2. ENTER A: to make the A: drive the
current drive.
3. ENTER
LOADRAM E:XXXX.C C: /C/M/S/NE
(Where XXXX equals the EIA location for
the CPC EXAMPLE=A18A.
4. ENTER
LOADRAM C:IQYBCBK1.RAM C:
/C/M/S/NE (Where XXXX equals the EIA
location for the CPC EXAMPLE=A18A.
5. ENTER
LOADRAM C:IQYBFBKP.RAM F:
/C/M/S/NE (Where XXXX equals the EIA
location for the CPC EXAMPLE=A18A.
6. ENTER
LOADRAM E:XXXX.D D: /C/M/S/NE
(Where XXXX equals the EIA location for
the CPC EXAMPLE=A18A.
3 Clean-up
1. ENTER ERASE E:\*.*
2. ENTER ERASE C:\*.RAM
3. Remove the SE-RESTORE1 diskette from
the Support Element drive A:.
4. Press ALT+CTRL+DELETE to re-boot the
Support Element
4 Completing the Installation
1. When all Support Element associated with
the CPC's listed on the CPC LOCATIONS
DISKETTE have been configured the CPC
will be left in a undefined state to the
Hardware Management Console it will be
necessary to go to "Defining Support
Element to the Hardware Management
Console" on page 6-10 to define the
Support Element to the Hardware
Management Console
6-68
Installing the System
Note: Repeat this procedure on the Support
Element associated with the next CPC on
the CPC LOCATIONS diskette label.
Continue to repeat this procedure until all
Support Element associated with the CPC
listed on the CPC LOCATIONS diskette
have been configured.