ASDA-A2
2.9.2 Mounting Directions and Precautions for the Servo Motor
You can install the servo motor horizontally or vertically.
Orientation
Horizontal
Vertical (with shaft end up)
Vertical (with shaft end down)
Note: if you need to install gears on the servo motor, please follow the manufacturer's instructions for installation.
2-22
If you are using a servo motor with oil seal, please refer to
the precaution measures in section 2.9.5 for preventing
oil / water from entering the servo motor.
Do not use servo motors with oil seal in the vertical
orientation.
When wiring, you need to install an oil trap (marked as
(1) in the left) to prevent vapor from entering the motor.
When installing the servo motor in a machine (such as
a gearbox), you must comply with the precaution
measures in section 2.9.5 to prevent oil and gas from
entering the servo motor.
If you are using a servo motor with oil seal, please refer to
the precaution measures in section 2.9.5 for preventing
oil / water from entering the servo motor.
Precautions
Chapter 2 Installation