Installation; Notes; Ambient Conditions Of Storage; Ambient Conditions Of Installation - Delta ASD-A2-0121 Series User Manual

2.1 Notes

Please pay special attention to the followings:
If the connection between the servo drive and the servo motor is over 20 meters (65.62 feet),

please thicken the connecting wire, UVW, as well as the encoder cable. Please refer to
Section 3.1.6 for further information.

2.2 Ambient Conditions of Storage

Before the installation, this product has to be kept in the shipping carton. In order to retain the
warranty coverage and for the maintenance, please follow the instructions below for storage, if the
product is not in use temporarily:
Store the product within an ambient temperature range of -20°C to +65°C (-4°F to 149°F).

Store the product within a relative humidity range of 0% to 90% and a non-condensing

environment.
Avoid storing the product in the environment containing corrosive gas and liquid.


2.3 Ambient Conditions of Installation

The ambient conditions of installing and operating the servo drive:
A location that has no over-heat device, no water drop, vapor, dust and oily dust, no corrosive and
inflammable gas and liquid, no airborne dust and metal particles, no interference of
electromagnetic noise and has solid foundation and no vibration.
The ambient conditions of operating the servo motor:
The ambient temperature is between 0°C and 40°C (32°F to 104°F). And the ambient location shall
have no over-heat device, no water drop, vapor, dust and oily dust, no corrosive and inflammable
gas and liquid, no airborne dust and metal particles.
The best temperature of this servo drive is between 0°C and 55°C (32°F to 131°F). If the
temperature is over 45°C (113°F), please place the product in a well-ventilated environment so as
to ensure its performance. If the product is installed in a distribution board, make sure the size of
the distribution board and its ventilation condition will not overheat and endanger the internal
electronic device. Also, pay attention to the vibration of the machine. Check if the vibration will
influence the electronic device of the electric box.
Chapter 2 Installation
2-1