Chapter 2 Installation And Storage; Installation Notes; Storage Conditions - Delta ASDA-A2 Series User Manual

2.1

Installation Notes

Please pay close attention on the following installation notes:
Do not bend or strain the connection cables between servo drive and motor.
When mounting the servo drive, make sure to tighten all screws to secure the drive in place.
If the servo motor shaft is coupled directly to a rotating device ensure that the alignment specifications of
the servo motor, coupling, and device are followed. Failure to do so may cause unnecessary loads or
premature failure to the servo motor.
If the length of cable connected between servo drive and motor is more than 20m, please increase the
wire gauge of the encoder cable and motor connection cable (connected to U, V, W terminals).
Make sure to tighten the screws for securing motor.
2.2

Storage Conditions

The product should be kept in the shipping carton before installation. In order to retain the warranty coverage,
the AC servo drive should be stored properly when it is not to be used for an extended period of time. Some
storage suggestions are:
Store in a clean and dry location free from direct sunlight.
Store within an ambient temperature range of -20°C to +65°C (-4°F to 149°F).
Store within a relative humidity range of 0% to 90% and non-condensing.
Do not store in a place subjected to corrosive gases and liquids.
Correctly packaged and placed on a solid surface.
Revision April, 2010

Chapter 2 Installation and Storage

2-1