Pto Shaft - Toro Groundsmaster 3280-D Service Manual

PTO Shaft

g220805
1. Bolt
2. Lock washer
3. Flat washer
4. PTO drive belt
5. PTO pulley
6. Carriage screw (4 each)
Removing the PTO Shaft
PTO System: Service and Repairs
7. PTO tension shaft
8. Flange nut (8 each)
9. Woodruff key
10. PTO shaft
11. PTO bearing bracket
12. Bushing support plate
Do not start the engine and engage the PTO switch when the PTO
driveshaft is disconnected from the cutting deck (or implement). If
you start the engine and the PTO shaft is allowed to rotate, serious
personal injury and machine damage could result.
Disconnect the PTO electric clutch electrical connector whenever the
PTO driveshaft is disconnected from the cutting deck (or implement).
1. Park the machine on a level surface, lower the cutting deck (or implement),
shut off the engine, set the parking brake, and remove the key from the
key switch.
2. Remove the PTO driveshaft from the machine; refer to
Driveshaft (page 9–5).
3. Remove the PTO drive belt from the machine; refer to the Traction Unit
Operator's Manual.
Figure 293
13.
14.
15.
16.
17.
18.
WARNING
Page 9–8
Flange bearing (2 each)
Bolt (2 each)
Flat washer (4 each)
Rubber mount (2 each)
Bolt (4 each)
Locknut (2 each)
Removing the PTO
Groundsmaster ® 3280-D/3320
05138SL Rev B