Toro Groundsmaster 3280-D Service Manual page 441

Assembling the Blade Spindle
Groundsmaster ® 3280-D/3320
05138SL Rev B
g189007
1. Bearing
2. Spacer ring
Note: A replacement spindle bearing set contains 2 bearings, a spacer ring,
and a large snap ring (items 1, 2, and 3 in
these parts separately. Also, do not mix the bearing set components from one
deck spindle to the another.
Note: A replacement bearing spacer set includes the inner spacer and outer
spacer (items 4 and 5 in
deck spindle to the another.
If new bearings are installed into a used spindle housing, it is not
necessary to replace the original large snap ring. If the original snap
ring is in good condition with no sign of damage (e.g., spun bearing),
leave the snap ring in the housing and discard the snap ring that
comes with the new bearings. If the large snap ring is damaged,
replace the snap ring.
1. If the large snap ring was removed from the spindle housing, install the snap
ring into the housing groove.
Note: Ensure that the snap ring is fully seated in the housing groove.
2. Install the outer spacer into the top of the spindle housing.
Note: Ensure that the outer spacer fits against the snap ring.
Figure 299
3. Large snap ring
4. Inner spacer
Figure
Figure 299). Do not mix the bearing spacers from one
IMPORTANT
Page 10–11
5. Outer spacer
299). You cannot purchase
Cutting Units: Service and Repairs