Rear Axle Driveshaft (4-Wheel Drive) - Toro Groundsmaster 3280-D Service Manual

Rear Axle Driveshaft (4-Wheel Drive)

g226458
1. Bi-directional clutch
2. Lock washer (6 each per flange)
3. Socket-head screw (6 each per
flange)
4. Cross and bearing kit (2 each)
Removing the Rear Axle Driveshaft (4-Wheel Drive)
Groundsmaster ® 3280-D/3320
05138SL Rev B
5. Grease fitting (2 each)
6. Yoke and shaft
7. Grease fitting
8. Front axle flange
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Support the driveshaft to prevent it from falling.
3. Remove the 6 socket-head screws and 6 lock washers that secure the
driveshaft front yoke flange to the front axle flange (item 8 in
4. Remove the 6 socket-head screws and 6 lock washers that secure the
driveshaft rear yoke flange to the bi-directional clutch (item 1 in
5. Remove the rear axle driveshaft from the machine.
Figure 253
10.
Page 8–43
9. Yoke flange (2 each)
Yoke and tube
Figure
Figure
Drive Axles: Service and Repairs
253).
253).