Table of Contents
Advertisement
Note:
When tightening the jam nut, hold the ball
joint straight to permit proper oscillation during
raising and lowering of the cutting unit.
4
Connecting the PTO Shaft
and Guard to the Cutting
Unit Gearbox
No Parts Required
Procedure
1.
Remove the 2 capscrews and lock washers that
secure the PTO guard mounting brackets to the
gearbox
(Figure
1. PTO guard
Note:
Retain the fasteners for future installation.
2.
Slide the PTO shaft guard onto the PTO shaft,
positioning the guard as shown in
3.
Slide the male PTO shaft into the female PTO
shaft.
Note:
Align the mounting holes in the gear case
input shaft with the holes in the PTO shaft and
slide them together.
4.
Secure them with a roll pin.
5.
Tighten the capscrews and nuts.
6.
Attach the PTO shaft guard to the gearbox with
the 2 capscrews and lock washers previously
removed.
8).
Figure 8
2. Gearbox
Figure
5
Installing the Rear Weight
No Parts Required
Procedure
Two-Wheel Drive Groundsmaster 1000 and 200
Series traction units comply with EN ISO 5395 and
ANSI B71.4-2017 when equipped with rear weight.
Refer to the chart in the traction unit Operator's
Manual to determine the combinations of weight
required. Order the parts from your local authorized
Toro distributor.
Four-Wheel Drive Groundsmaster 200 Series traction
units do not need additional rear weight to comply with
EN ISO 5395 and ANSI B71.4-2017.
Two-Wheel Drive Groundsmaster 3280-D and
Groundsmaster 3320 traction units with serial
numbers 250000101 through 259999999 comply with
EN ISO 5395 and ANSI B71.4-2017 when equipped
with the rear weight kit, Part No. 24-5780.
Two-Wheel Drive Groundsmaster 3280-D and
Groundsmaster 3320 traction units with serial
numbers 260000101 and up do not need additional
rear weight to comply with EN ISO 5395 and ANSI
B71.4-2017.
g010546
Four-Wheel Drive Groundsmaster 3280-D traction
units do not need additional rear weight to comply with
EN ISO 5395 and ANSI B71.4-2017.
6
8.
Greasing the Machine
No Parts Required
Procedure
Before operating the machine, grease it to ensure
proper lubricating characteristics; refer to
(page
18). Failure to properly grease the machine will
result in premature failure of critical parts.
11
Lubrication
Advertisement
Table of Contents
