Toro Groundsmaster 3280-D Service Manual page 349

Disassembling the Brake (continued)
Assembling the Brake
Groundsmaster ® 3280-D/3320
05138SL Rev B
6. Remove the adjuster spring (item 13 in
7. Spread the upper ends of the brake shoes (item 11 in
remove the star wheel socket, star wheel adjuster, and pivot nut.
8. Remove the brake lever retainers (item 14 in
9. Pull the brake lever from the brake shoes.
10. Remove the return springs (items 7 and 15 in
by prying the end of the spring up and out of the brake shoe. Use a brake
spring pliers or flat blade screwdriver.
11. Slide both brake shoes from the brake spider, and remove the shoes from
the machine.
1. Slide the brake shoes (item 11 in
The springs are under tension and could possibly slip during
installation.
Be careful when installing the brake return and adjuster springs.
2. Position the return springs (items 7 and 15 in
3. Position the brake lever (item 17 in
the brake lever to the shoes with the brake lever retainers.
4. Spread the upper ends of the brake shoes, and install the star wheel socket,
star wheel adjuster, and pivot nut.
5. Install the adjuster spring (item 13 in
6. Install the brake drum on the wheel studs.
7. Secure the brake cable to the brake lever with the clevis pin (item 4 in
196) and cotter pin. Attach the brake return spring to the brake cable link.
8. Install the wheel assembly to the front axle; refer to
(page 7–5).
9. Check and adjust the brakes; refer to the Traction Unit Operator's Manual.
Figure
Figure 196) up onto the brake spider.
CAUTION
Figure 196) to the brake shoes. Secure
Figure
Page 8–7
196).
Figure 196), and
Figure 196).
Figure 196) and brake shoe
Figure 196) to the brake shoes.
196).
Installing the Wheel
Drive Axles: Service and Repairs
Figure