Toro Groundsmaster 3280-D Service Manual page 45

Removing the Fuel Tank (continued)
Installing the Fuel Tank
Groundsmaster ® 3280-D/3320
05138SL Rev B
g230318
1. Knob
2. Flange-head screw
3. Choke control
6. Remove flange-head screws and flange nut that secure lower control panel
to machine (Figure
7. Remove locknut (item 31 in
8. Use a fuel transfer pump to remove fuel from the fuel tank and into a suitable
container.
9. Disconnect fuel hoses from standpipe (item 22 in
on the top of the fuel tank.
10. Remove fuel tank (Figure
1. Install fuel tank to frame
2. Connect fuel hoses to standpipe (item 22 in
the top of the fuel tank. Secure hoses with clamps.
3. Secure lower control panel to machine with flange-head screws and flange
nut (Figure 12).
4. Secure tank to left fender with flat washer (item 32 in
5. Position control panel to fuel tank, connect wire harness to panel
components, and secure panel to machine with thumb screws.
6. Install seat plate to machine.
7. Install seat suspension and seat to machine; refer to
Seat (page 7–20).
8. Connect seat switch to machine wire harness. Close hood.
9. Fill fuel tank; refer to the Traction Unit Operator's Manual.
Figure 12
4. Lower control panel
5. Throttle control
6. Lift control lever
12).
Figure 11) and flat washer from left fender.
11).
(Figure 11).
Page 3–11
7. Flange nut
Figure 11) and elbow fitting
Figure 11) and elbow fitting on
Figure 11) and locknut.
Installing the Operator
Gasoline Engine: Service and Repairs