Toro Groundsmaster 3280-D Service Manual page 363

Removing the Front Axle (continued)
Installing the Front Axle
Groundsmaster ® 3280-D/3320
05138SL Rev B
13. Carefully lower the front axle and remove the axle from the machine.
1. Position the front axle to the machine frame and support the axle in place.
2. Place the axle shims in the location that you noted during disassembly.
Install the 4 bolts (item 17 in
secure the axle mounting pads to the frame. Leave the fasteners loose to
allow alignment of hydraulic motor.
3. Connect the brake cable (item 3 in
brake .Secure the brake cables to the axle brackets with the jam nuts.
When installing the hydraulic motor, ensure that the hydraulic motor
driveshaft alignment is checked and adjusted if necessary.
4. Install the hydraulic motor to the machine; refer to
Drive Motor (page
5. Install the 2 front wheels to the front axle; refer to
7–5).
6. Install the 2 carrier brackets (item 20 in
7. Install the lift arms to the machine; refer to
7–28).
8. Install the fuel tank; refer to
9. Lubricate and install new O-ring to the straight thread fitting. Install the
straight thread fitting (with the oil filter) to the front axle and secure the oil
filter to the filter bracket with the 2 flange-head screws (item 9 in
10. Fill the hydraulic reservoir (front axle) with hydraulic fluid; refer to the Traction
Unit Operator's Manual.
11. Install the cutting deck (or implement); refer to the Cutting Unit Operator's
Manual.
Figure 212), 4 flat washers, and 4 locknuts that
Figure
IMPORTANT
5–108).
Figure
Installing the Fuel Tank (page
Page 8–21
213) to the brake lever on each
Installing the Front Axle
Installing the Wheel (page
212) to the machine frame.
Installing the Lift Arms (page
4–17).
Figure
Drive Axles: Service and Repairs
212).