Toro Groundsmaster 3280-D Service Manual page 66

Removing the Exhaust System (continued)
Installing the Exhaust System
Diesel Engine: Service and Repairs
3. Remove the 2 bolts (item 7 in
nuts that secure the exhaust muffler to the muffler mount.
4. Remove the 4 flange nuts (item 3 in
studs.
5. Loosen the alternator bolt, and move the upper alternator brace away from
the muffler.
6. Remove the exhaust muffler from the machine.
7. Remove and discard the gasket (item 1 in
Note: Ensure that the exhaust muffler flange and engine exhaust manifold
sealing surfaces are free of debris or damage that may prevent a tight seal.
1. Place new gasket (item 1 in
Finger tighten all the fasteners before securing the muffler to the
muffler mount so there is no preload on the exhaust system.
2. Position the exhaust muffler and upper alternator brace to the engine exhaust
manifold and loosely install the 4 flange nuts
3. With the muffler flange tight to the engine exhaust manifold (no gaps visible),
position the muffler so that the muffler is tight against the muffler mount (no
gaps visible).
4. Tighten the 4 flange nuts to secure the muffler flange to the exhaust manifold.
5. Secure the exhaust muffler to the muffler mount with the 2 bolts (item 7 in
Figure 24), 4 hardened washers, and 2 flange nuts.
6. Lower the hood and secure it with the latches.
Figure 24), 4 hardened washers, and 2 flange
Figure
Figure
Figure 24) on the engine exhaust manifold.
IMPORTANT
Page 4–10
24) from the exhaust manifold
24).
(Figure 24).
Groundsmaster ®
05138SL Rev B
3280-D/3320