Toro Groundsmaster 3280-D Service Manual page 354

Disassembling the Front Axle Shafts and Bearings (continued)
Assembling the Front Axle Shafts and Bearings
Drive Axles: Service and Repairs
11. Remove and discard the outer seal plate.
g225891
12. Inspect all the components for wear and damage
the axle shaft if the seal has grooved the axle surface more than 0.40 mm
(1/64 inch).
1. Coat a new outer seal plate with a thin layer of fluid and place the outer seal
plate, brake assembly, and dust shield in position on the axle shaft.
g225892
2. Pack the bearing with grease and press it onto the axle shaft
Drive the bearing onto the axle shaft by pressing on the inner race
of the bearing only.
Figure 204
Figure 205
IMPORTANT
Page 8–12
(Figure 204). Replace
(Figure 205).
Groundsmaster ® 3280-D/3320
05138SL Rev B