Toro Groundsmaster 3280-D Service Manual page 336

Removing the Mechanical Seat Suspension
Installing the Mechanical Seat Suspension
Chassis: Service and Repairs
g223699
1. Seat bracket (right)
2. Seat bracket (left)
3. Flange-head screw (8
each)
4. Flange nut (12 each)
1. Park the machine on a level surface, lower the cutting deck (or implement),
shut off the engine, set the parking brake, and remove the key from the
key switch.
Do not damage the electrical harness when removing the seat
suspension from the machine.
2. Remove the seat and seat suspension from the machine; refer to
Seat (page 7–19).
3. Remove the mechanical seat suspension components as necessary
186 and Figure 187). If the seat adjusters are being removed, record the
seat adjuster mounting holes used.
1. Install all the mechanical seat suspension components that were removed
(Figure 186 and Figure
holes that were recorded during removal.
Do not damage the electrical harness when installing the seat
suspension to the machine.
Figure 187
5. Wire cap (4 each)
6. Lower seat bracket (2
each)
7. Flange-head screw (4
each)
8. Mechanical suspension
assembly
IMPORTANT
187). If removed, use the seat adjuster mounting
IMPORTANT
Page 7–22
9. Flat washer (8 each)
10. Seat adjuster
11. Socket-head screw (4
each)
12. Seat adjuster with latch
Operator
(Figure
Groundsmaster ® 3280-D/3320
05138SL Rev B