Toro Groundsmaster 3280-D Service Manual page 53

Removing the Engine (continued)
Installing the Engine
Groundsmaster ® 3280-D/3320
05138SL Rev B
g230312
1. Gasoline engine
2. Engine bracket
3. Flat washer
17. If necessary, remove engine brackets from engine
1. Locate machine on a level surface with cutting deck (or implement) lowered
and key removed from the key switch. Chock wheels to keep the machine
from moving.
2. Ensure that all parts removed from the engine during maintenance or building
are installed to the engine.
3. If engine brackets were removed from the engine, install them to engine
(Figure 19).
4. If engine mount brackets (items 20 and 28 in
frame, secure them to frame with bolts and lock washers. Torque screws to
68 to 81 N∙m (50 to 60 ft−lb).
The left, rear shock mount (item 15 in
other 3 mounts. If shock mounts were removed from engine mount
brackets on frame, ensure that the shock mount with red patch is
correctly installed at left, rear position.
5. Position fan shroud around the engine fan.
6. Reinstall engine to machine.
A. Attach short section of chain between lift tabs located on each end of
the cylinder head
B. Connect a hoist or chain fall at the center of the short section of chain.
Apply enough tension on the short chain so that the engine can be
supported.
Figure 19
4. Bolt
5. Pivot plate
6. Engine bracket
IMPORTANT
Figure
Page 3–19
7. Engine bracket
(Figure 19).
Figure 15) were removed from
15) is different than the
Gasoline Engine: Service and Repairs