Remote Starter Switch - Toro Groundsmaster 3280-D Service Manual

Remote Starter Switch

Groundsmaster ® 3280-D/3320
05138SL Rev B
After flushing the hydraulic system or
replacing a hydraulic component (e.g.
gear pump, piston pump, drive motor), it is
necessary to prime the hydraulic pumps.
A remote starter switch can be used for
this purpose. A remote starter switch
can be purchased locally or fabricated as
follows.
IMPORTANT: When using a
remote starter switch, it is highly
recommended to include a 20 amp
in−line fuse between the battery and
switch connector for circuit protection.
A remote stater switch can also be
constructed using Toro switch #106−2027,
a length of 14 gauge wire, a 20 amp
in−line fuse, two (2) alligator clips and
necessary connectors. Connecting the
wire to switch terminals 1 and 2 will allow
the momentary switch contacts to be used
for the remote starter switch.
Note: For information on using the remote
starter switch to prime the hydraulic
pumps.
g225779
1. Starter solenoid
A remote stater switch can also be constructed using the Toro switch #106-2027,
a length of 14 gauge wire, a 20 A in-line fuse, 2 alligator clips, and necessary
connectors. Connecting the wire to switch terminals 1 and 2 will allow the
momentary switch contacts to be used for the remote starter switch ().
Note: For information on using the remote starter switch to prime the hydraulic
pump; refer to Priming the Hydraulic Pump (page
Remote Starter Switch (purchased)
Remote Starter Switch (fabricated)
Figure 58
2. Starter motor
Page 5–43
3. B+ terminal
5–79).
Hydraulic System: Special Tools