Assembling the Front Axle Shafts and Bearings (continued)
Groundsmaster
®
3280-D/3320
05138SL Rev B
g225893
3. Slide a new bearing retainer on the axle shaft. Support the shaft and retainer
in a suitable press and press the bearing retainer firmly against the bearing
(Figure
206).
Do not heat the bearing retainer to install. Heat will destroy the close
tolerance press fit.
g225894
4. Prepare a new inner shaft seal for assembly. Put a light coat of No. 1
Permatex (or equivalent) on the outer diameter (surface that contacts the
axle housing), and a thin layer of fluid on the inner diameter (surface that
contacts the axle shaft). Install new seal to a depth of 30.90 mm (1.218
inches) into the axle housing
Figure 206
IMPORTANT
Figure 207
(Figure
207).
Page 8–13
Drive Axles: Service and Repairs