Toro Groundsmaster 3280-D Service Manual page 268

Accessory Power Switch (Machines with Operator Cab)
g243784
1. Switch panel
Testing the Accessory Power Switch
Electrical System: Testing the Electrical Components
The accessory power switch controls the power supply to the accessory power
outlet. The switch is located in the cab headliner
1. Park the machine on a level surface, lower the cutting deck, set the parking
brake, and shut off the engine.
2. To access the accessory power switch, remove the roof from the top of the
cab; refer to Roof Assembly (page
3. Remove the switch panel from the cab headliner.
4. Disconnect the wire harness electrical connector from the accessory power
switch.
g243573
5. The accessory power switch terminals are identified in
circuitry of the switch is shown in the
the use of a multimeter (ohms setting), test the switch functions to determine
if continuity exists between the various terminals for each switch position.
Check the continuity between the switch terminals.
Figure 140
2. Accessory power switch
11–3).
Figure 141
Back of Switch
Circuit Logic Table (page
Page 6–40
(Figure 140).
Figure 141 and the
6–41). With
Groundsmaster ® 3280-D/3320
05138SL Rev B