Toro Groundsmaster 3280-D Service Manual page 52

Removing the Engine (continued)
Gasoline Engine: Service and Repairs
12. Disconnect hoses from engine.
A. Loosen clamps and disconnect upper and lower radiator hoses from
the engine.
B. At carburetor, loosen hose clamp and disconnect fuel hose. Plug hose to
prevent leakage and contamination.
13. Disconnect transmission driveshaft from engine pulley; refer to
Transmission Driveshaft (page
14. Remove cotter pin and clevis pin that secure hood cable to muffler bracket
on rear of engine. Support hood in the open position.
15. Disconnect wire harness connectors from the following engine components:
Note: Label all electrical leads for reassembly purposes.
A. Alternator connector and stud.
B. High temperature shut down switch and temperature sender located on
the water pump housing.
C. Fuel solenoid on carburetor.
D. Oil pressure switch located near the engine oil dipstick.
E. Ignition coils located on the right side of the engine.
F. Connector, fusible link connector, and positive battery cable from the
starter motor.
G. Wire harness ground wire from the muffler bracket.
H. PTO clutch wire connector.
I. Crank position wire connector.
16. Remove engine from machine:
A. Attach short section of chain between lift tabs located on each end of
the cylinder head.
B. Connect a hoist or chain fall at the center of the short section of chain.
Apply enough tension on the short chain so that the engine will be
supported.
C. Remove fasteners that secure the engine (with brackets) to the engine
shock mounts and engine mount brackets.
One person should operate lift or hoist while the other person
guides the engine out of the machine.
Ensure not to damage the engine, fuel hoses, hydraulic lines,
electrical harness, or other parts while removing the engine.
D. Raise engine and remove from machine.
5–87).
CAUTION
IMPORTANT
Page 3–18
Removing the
Groundsmaster ® 3280-D/3320
05138SL Rev B