Toro Groundsmaster 3280-D Service Manual page 360

Removing the Front Axle (continued)
Installing the Front Axle
Drive Axles: Service and Repairs
13. Put a jack or blocking under front axle to prevent it from falling. Remove
bolts, flat washers, and locknuts that secure axle mounting pads to frame.
Retrieve and note location of axle shims (item 19 in
14. Carefully lower front axle and remove from machine.
1. Position front axle to machine frame and support axle in place.
2. Place axle shims in location noted during disassembly. Install bolts, flat
washers, and locknuts that secure axle mounting pads to frame. Leave
fasteners loose to allow alignment of transmission.
3. Connect the brake cables to the brake actuating levers on each brake
211). Secure brake cables to axle brackets with jam nuts.
When installing hydrostatic transmission, ensure that the
transmission driveshaft alignment is checked and adjusted if
necessary.
4. Install hydrostatic transmission to machine; refer to
Transmission (page
5. Install front wheels to axle and secure with wheel-lug nuts. Torque wheel-lug
nuts in a crossing pattern to 102 to 108 N∙m (75 to 80 ft-lb).
6. Install carrier brackets (item 14 in
7. Install lift arms to the machine; refer to
8. Install fuel tank; refer to
the Fuel Tank (page
9. Install hydraulic hose (item 22 in
with hose clamp.
10. Lower the machine to ground.
11. Fill hydraulic reservoir (front axle) with hydraulic fluid; refer to the Traction
Unit Operator's Manual.
12. Install the cutting deck (or implement); refer to the Cutting Unit Operator's
Manual.
IMPORTANT
5–92).
Figure 210) to the machine frame.
Lift Arms (page
Installing the Fuel Tank (page 3–11)
4–17).
Figure 210) to fitting on axle and secure
Page 8–18
Figure 210).
(Figure
Installing the Hydrostatic
7–26).
or Installing
Groundsmaster ® 3280-D/3320
05138SL Rev B