Toro Groundsmaster 3280-D Service Manual page 400

Removing the Differential Shaft (4-Wheel Drive Axle) (continued)
Installing the Differential Shaft (4-Wheel Drive Axle)
Drive Axles: Service and Repairs
5. Inspect all gears, shafts, bearings, and cases for damage and wear. Replace
the components as necessary.
1. Press the bearings onto the differential shaft. Place correct combination of
bearing shims in the axle support and drive the differential shaft and bearing
assembly into the axle support.
2. Install the bevel gear and retaining ring.
3. Coat new O-ring with grease. Align the differential shaft splines with the
differential gear assembly and slide the differential shaft assembly onto the
axle support.
4. Install the bevel gear case/axle case assembly; refer to
Axle Case (4-Wheel Drive Axle) (page 8–49).
Page 8–58
Bevel Gear Case and
Groundsmaster ® 3280-D/3320
05138SL Rev B