Table of Contents
Advertisement
7.
Install the height of cut collars onto the height
of cut rods and secure with the clevis pins and
hairpin cotters
(Figure
the clevis pin toward the front of the deck, if
possible.
8.
Install a bolt (1/2 x 3/4 inch) and a washer to top
of each height of cut rod
6
Connecting the PTO Shaft
to the Cutting Unit Gearbox
No Parts Required
Procedure
1.
Slide the male PTO shaft into the female PTO
shaft
(Figure
6). Align the mounting holes in the
gear case input shaft with the holes in the PTO
shaft and slide them together.
1. PTO shaft
2. Bolts and locknuts
2.
Secure them with a roll pin
3.
Tighten the bolts and nuts
5). Position the head of
(Figure
5).
Figure 6
3. Gear case
4. Roll pin
(Figure
6).
(Figure
6).
7
Greasing the Machine
No Parts Required
Procedure
Before operating the machine, it must be greased to
ensure proper lubricating characteristics; refer to
Greasing the Machine (page
grease the machine will result in premature failure of
critical parts.
g012230
10
7
10). Failure to properly
Advertisement
Table of Contents
