Toro Groundsmaster 3280-D Service Manual page 454

Removing the Roof Assembly
Installing the Roof Assembly
Operator Cab: Service and Repairs
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Remove the 16 washer-head screws (item 1 in
roof cover, cover seals, and roof straps to the roof.
3. Remove the 22 shoulder screws (item 5 in
22 flange nuts that secure the roof and cab straps to the headliner.
4. Carefully lift the roof from the headliner and cab.
5. Inspect all the roof seals for wear or damage. Replace the roof seals as
necessary.
1. Ensure that all the components in the headliner are installed and secure.
2. Position the roof onto the headliner. Ensure that all the roof mounting holes
are correctly aligned with the headliner.
3. Secure the roof to the headliner with the 22 shoulder screws (item 5 in
308), 22 flat washers, cab straps, and 22 flange nuts that were removed.
4. Secure the roof cover, cover seals, and roof straps to the roof with the 16
washer-head screws that were removed.
Figure
Page 11–4
Figure 308) that secure the
308), 22 flat washers, and
Groundsmaster ® 3280-D/3320
05138SL Rev B
Figure