Jacking Instructions; Safety And Instructional Decals - Toro Groundsmaster 3280-D Service Manual

Jacking Instructions

Raising the Front of the Machine
Raising the Rear of the Machine

Safety and Instructional Decals

Safety: Jacking Instructions
Failing to properly support the machine with appropriate jack stands
can cause the machine to move or fall and can result in personal
injury.
When changing the attachments, tires, or performing other services,
do the following steps:
• Use correct blocks, hoists, and jacks to raise and support the
machine.
• Park the machine on a solid level surface, such as a concrete
floor.
• Before you lift the machine, remove all the attachments that may
interfere with the safe and correct lift of the machine.
• Always block the wheels with chocks.
• Use appropriate jack stands to support the raised machine.
• Do not use the cutting deck or implement as a jacking point.
1. Set the parking brake and block the 2 rear wheels with chocks to prevent
the machine from moving.
2. Position the jack securely under the frame (not the axle), just to the inside of
the front wheel.
3. Use a jack to raise the front of the machine.
4. Position jack stands or hardwood blocks under the frame as close to the
wheel as possible to support the machine.
1. Set the parking brake and block the 2 front wheels with chocks to prevent
the machine from moving.
2. Position the jack securely under the frame (not the axle) directly in front
of the rear axle.
3. Jack rear of the machine off the ground.
4. Position the jack stands or hardwood blocks under the frame to support
the machine.
Numerous safety and instruction decals are affixed to the traction unit and
cutting units of your Groundsmaster. If any decal becomes illegible or damaged,
install a new decal. Decal part numbers are listed in your Parts Catalog. Order
replacement decals from Authorized Toro Distributor.
CAUTION
Page 1–6 Groundsmaster ® 3280-D/3320
05138SL Rev B